K1 employs a single D50 mid range driver (patent pending), between 900Hz and 4 kHz with the range beyond being handled by a D26 tweeter (patent pending). Below 900Hz the K1 uses four C125 mid-bass drivers (patent pending), two mounted on the front baffle and two mounted on the rear baffle of the cabinet. These four drivers are internally coupled in pairs via screw tensioning units for reaction cancelling. All drivers receive the same signal at frequencies below 100Hz while above this point the drive to the rear is progressively attenuated leaving only the front upper driver to operate all the way to 900Hz to ensure good vertical dispersion at crossover. Fourth order filters ensure phase coherence through both main crossover points resulting in a seamless and symmetrical polar performance.

Integral to the K1 enclosure is the stand. Made from the same cast carbon fibre reinforced polyester compound as the enclosure, the stand provides an exceptionally stable footing further guaranteed by the use of a total of five custom spikes mounted around the periphery of the base. Adjustment of the two rear spikes and that at the front sets the correct attitude while the remaining two can then be brought into contact with the floor for maximum safety.

Within each of the streamlined arms are hidden separate conduits to guide the Van den Hul® interconnecting cable away from the two internally mounted crossovers into the base. Precision machined WBT® gold plated terminals are discretely located at the rear of the base to allow a visually unobtrusive connection to the outside world.